REAR AIRBAG SENSOR(w/o Rear No. 2 Seat) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR LH


    1. A002LL4

      Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the rear airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the rear airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  3. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  4. INSTALL DECK TRIM SIDE SERVICE HOLE COVER

    Click here

  5. INSTALL FRONT DECK SIDE TRIM COVER LH

    Click here

  6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  8. INSTALL REAR DECK TRIM COVER

    Click here

  9. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  10. INSTALL DECK FLOOR BOX LH

    Click here

  11. INSTALL DECK FLOOR BOX RH

    Click here

  12. INSTALL LOWER DECK TRIM SIDE BOARD LH

    Click here

  13. INSTALL LOWER DECK TRIM SIDE BOARD RH

    Click here

  14. INSTALL FRONT DECK FLOOR BOX

    Click here

  15. INSTALL NO. 2 DECK BOARD

    Click here

  16. INSTALL NO. 1 DECK BOARD

    Click here

  17. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    CAUTION:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  19. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.