REAR AIRBAG SENSOR(w/ Rear No. 2 Seat) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AIRBAG SENSOR LH

   
   

   1. 

      Turn the ignition switch off.

   2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Install the rear airbag sensor with the bolt.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      
      

      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

   4. Check that the rear airbag sensor is not loose.

   5. Connect the connector.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

   Click here

3. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

   Click here

4. INSTALL DECK TRIM SIDE SERVICE HOLE COVER

   Click here

5. INSTALL FRONT DECK SIDE TRIM COVER LH

   Click here

6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

   Click here

7. INSTALL REAR DOOR SCUFF PLATE LH

   Click here

8. INSTALL REAR DECK TRIM COVER

   Click here

9. INSTALL REAR NO. 2 SEAT ASSEMBLY

   Click here

10. INSTALL REAR NO. 2 SEAT TRACK COVER

    Click here

11. INSTALL REAR NO. 2 SEAT TRACK BRACKET COVER

    Click here

12. INSTALL DECK TRIM SIDE BELT HOLE COVER LH

    Click here

13. INSTALL DECK TRIM SIDE BELT HOLE COVER RH

    Click here

14. INSTALL DECK FLOOR BOX LH

    Click here

15. INSTALL DECK FLOOR BOX RH

    Click here

16. INSTALL LUGGAGE COMPARTMENT TRAY (w/ Spare Tire)

    Click here

17. INSTALL DECK RAIL COVER (w/o Spare Tire)

    Click here

18. INSTALL DECK BOARD ASSEMBLY

    Click here

19. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    CAUTION:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

21. CHECK SRS WARNING LIGHT

    
    

    1. Check the SRS warning light Click here.