CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


    1. A002NKF

      Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the center airbag sensor with the 3 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note


      • If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the center airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  3. INSTALL FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  4. INSTALL FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  5. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (except Manual Transaxle)

    Click here

  6. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Manual Transaxle)

    Click here

  7. INSTALL SHIFTING HOLE COVER (for Manual Transaxle)

    Click here

  8. INSTALL POSITION INDICATOR HOUSING ASSEMBLY (except Manual Transaxle)

    Click here

  9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  10. INSTALL RADIO RECEIVER ASSEMBLY (w/ Audio)


    1. Install the radio receiver assembly Click here.

  11. INSTALL STEREO OPENING COVER WITH BRACKET (w/o Audio)

    Click here

  12. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Audio)

    Click here

  13. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  14. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  15. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  16. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY


    1. Install the rear console box sub-assembly Click here.

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  18. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.