SPIRAL CABLE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL SPIRAL CABLE SUB-ASSEMBLY


    1. A002M14

      Attach the 3 claws to install the spiral cable.

      CAUTION:

      When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

    2. Connect the connectors to the spiral cable.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL UPPER STEERING COLUMN COVER

    Click here

  3. INSTALL LOWER STEERING COLUMN COVER

    Click here

  4. ADJUST SPIRAL CABLE SUB-ASSEMBLY


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A002N0L

      Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

    4. A002QCJ

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

      Tech Tips

      The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center.

  5. INSTALL STEERING WHEEL ASSEMBLY


    1. Install the steering wheel assembly Click here.