PRE-COLLISION SYSTEM DIAGNOSIS SYSTEM


  1. CHECK DLC3


    1. Check the DLC3 Click here.

  2. FUNCTION OF WARNING INDICATOR AND MESSAGE


    1. If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message on the multi-information display in the combination meter assembly.

      Master Warning Light Multi-information Display PCS warning light Detail DTC
      Illuminates "PRE-COLLISION SYSTEM MALFUNCTION VISIT YOUR DEALER" Blinking This warning is displayed when the pre-collision city sensor detects a system malfunction ○

    2. Initial check


      1. The initial check occurs when the ignition switch is off for more than 2 seconds, and then turned to ON. The initial check consists of a pre-collision system diagnostic check with a duration of approximately 5 seconds.

      2. If a malfunction is detected during the initial check, "PRE-COLLISION SYSTEM MALFUNCTION VISIT YOUR DEALER" will be displayed on the multi-information display in the combination meter assembly 5 seconds after the initial check is complete and the PCS warning light will blink.

    3. Constant check


      1. The pre-collision city sensor constantly monitors the pre-collision system for malfunctions after the ignition switch is turned to ON and the initial check (approximately 5 seconds) has been completed.

      2. "PRE-COLLISION SYSTEM MALFUNCTION VISIT YOUR DEALER" is displayed on the multi-information display in the combination meter assembly if the constant check detects a malfunction in the pre-collision system.