METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips


    • Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    • Some items displayed on the tester may not be applicable depending on the vehicle specifications.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body or Powertrain / (desired system) / Data List.

    5. According to the display on the intelligent tester, read the Data List.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW ODO/TRIP switch (meter) condition/ON or OFF

      ON: ODO/TRIP switch pushed

      OFF: ODO/TRIP switch not pushed

      		 -
      ODO/TRIP Change SW ODO/TRIP switch (steering pad switch) condition/ON or OFF

      ON: ODO/TRIP switch pushed

      OFF: ODO/TRIP switch not pushed

      		 -
      P-Seatbelt Buckle SW Front passenger side seat belt warning light request signal/ON or OFF

      ON: Tongue plate (for front passenger side) not inserted

      OFF: Tongue plate (for front passenger side) inserted

      		 -
      Water Level SW Water level switch condition/ON or OFF

      ON: Water level warning switch on

      OFF: Water level warning switch off

      		 for 1WW
      Vehicle Speed Meter Vehicle speed/Min.: 0 (0), Max.: 255 (158) Almost same as actual vehicle speed (when driving) Unit: km/h (mph)
      Engine Rpm Engine speed/Min.: 0, Max.: 12750 Idling: 700 to 800 Unit: rpm
      Coolant Temperature Engine coolant temperature/Min.: 0 (0), Max.: 127.5 (261.5) After warming up: 80 to 95 (176 to 203)

      • Unit: °C (°F).

      • If the value is 0 (0), the sensor circuit is open.

      • If the value is 127.5 (261.5), the sensor circuit is shorted.
      Multi Display Select Switch Steering pad switch/ON or OFF

      ON: Steering pad DISP switch on

      Off: Steering pad DISP switch off

      		 -
      +B Voltage Value +B voltage/Min.: 0, Max.: 25.5 Between 1 and 14 Unit: V
      Fuel Input Fuel sender gauge input/Min.: 0, Max.: 127.5 Fuel sender gauge input value Unit: L
      Ambient Temperature Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 87.5°C (-40 to 189.5°F)
      2nd-Row Seatbelt Buckle (R) Buckle switch (Rear No. 1 seat RH side)/ON or OFF

      ON: Tongue plate (for rear No. 1 seat RH side) not inserted

      OFF: Tongue plate (for rear No. 1 seat RH side) inserted

      		 w/ Rear No. 1 Seat
      2nd-Row Seatbelt Buckle (L) Buckle switch (Rear No. 1 seat LH side)/ON or OFF

      ON: Tongue plate (for rear No. 1 seat LH side) not inserted

      OFF: Tongue plate (for rear No. 1 seat LH side) inserted

      		 w/ Rear No. 1 Seat
      2nd-Row Seatbelt Buckle (C)2 Buckle switch (Rear No. 1 seat center)/ON or OFF

      ON: Tongue plate (for rear No. 1 seat center) not inserted

      OFF: Tongue plate (for rear No. 1 seat center) inserted

      		 w/ Rear No. 1 Seat
      3rd-Row Seatbelt Buckle (R) Buckle switch (Rear No. 2 seat RH side)/ON or OFF

      ON: Tongue plate (for rear No. 2 seat RH side) not inserted

      OFF: Tongue plate (for rear No. 2 seat RH side) inserted

      		 w/ Rear No. 2 Seat
      3rd-Row Seatbelt Buckle (L) Buckle switch (Rear No. 2 seat LH side)/ON or OFF

      ON: Tongue plate (for rear No. 2 seat LH side) not inserted

      OFF: Tongue plate (for rear No. 2 seat LH side) inserted

      		 w/ Rear No. 2 Seat
      Oil Pressure Switch Oil pressure switch/ON or OFF

      ON: Oil pressure switch on

      OFF: Oil pressure switch off

      		 -
      Turn Signal Switch (Left) Turn signal switch (left) /ON or OFF

      ON: Turn signal switch (left) on

      OFF: Turn signal switch (left) off

      		 -
      Turn Signal Switch (Right) Turn signal switch (right) /ON or OFF

      ON: Turn signal switch (right) on

      OFF: Turn signal switch (right) off

      		 -
      Key Remind Sound Key reminder sound/Fast, Normal or Slow Current key reminder buzzer speed setting displayed w/o Entry and Start System
      Driver Side Seatbelt Warning Buzzer Driver side seat belt warning buzzer setting/ON or OFF

      ON: Driver side seat belt warning buzzer enabled

      OFF: Driver side seat belt warning buzzer disabled

      		 -
      P-Seatbelt Warning Buzzer Front passenger side seat belt warning buzzer setting/ON or OFF

      ON: Front passenger side seat belt warning buzzer enabled

      OFF: Front passenger side seat belt warning buzzer disabled

      		 -
      Rear Seatbelt Warning Buzzer Rear seat belt warning buzzer setting/ON or OFF

      ON: Rear seat belt warning buzzer enabled

      OFF: Rear seat belt warning buzzer disabled

      		 w/ Rear No. 1 Seat, w/ Rear No. 2 Seat
      ECO Drive Indicator Zone Eco driving indicator light signal/ON or OFF

      ON: Eco driving indicator light on

      OFF: Eco driving indicator light off

      		 for CVT
      ODO Display Time After IG OFF Setting Condition of the ODO display time/30 s, 60 s, 600 s or OFF Displays odometer display time setting -
      TPMS System*1 Existence of function/With or Without

      With: w/ Tire Pressure Warning System

      Without: w/o Tire Pressure Warning System

      		 -
      LDA System Existence of function/With or Without

      With: w/ Lane Departure Alert System

      Without: w/o Lane Departure Alert System

      		 -
      PCS System Existence of function/With or Without

      With: w/ Pre-collision System

      Without: w/o Pre-collision System

      		 -
      Number of Trouble Code Number of DTCs currently stored 0 -
      Engine (for ZR Series Engine)
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Engine Speed

      Engine speed/

      Min.: 0 rpm, Max.: 16383 rpm

      • 580 to 680 rpm: Idling (for Manual Transaxle)

      • 600 to 700 rpm: Idling (except Manual Transaxle)

      		 -
      Vehicle Speed

      Vehicle speed/

      Min.: 0 km/h, Max.: 255 km/h

      		 Actual vehicle speed The speed is indicated on the speedometer.
      Engine (for 1WW)
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Engine Speed

      Engine speed/

      Min.: 0 rpm, Max.: 16383 rpm

      		 Min.: 0 rpm, Max.: 16383 rpm When the crankshaft position sensor is malfunctioning, "Engine speed" is approximately 0 or varies greatly from the actual engine speed.
      Vehicle Speed

      Vehicle speed/

      Min.: 0 km/h, Max.: 255 km/h

      		 Actual vehicle speed -

  2. ACTIVE TEST

    Tech Tips


    • Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    • Some items displayed on the tester may not be applicable depending on the vehicle specifications.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Combination Meter / Active Test.

    5. According to the display on the intelligent tester, perform the Active Test.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation*1 Speedometer 0, 40, 80, 120, 160, 200 or 240 Perform the test with the vehicle stopped and the engine idling.
      Tachometer Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 Perform the test with the vehicle stopped and the engine idling.
      Fuel Meter Operation Fuel gauge Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F Perform the test with the vehicle stopped and the engine idling.
      A/T Indicator Operation 1*2 A/T indicator (normal mode) P, R, N, D, 4(M/S), 3(M/S), 2 or L Perform the test with the vehicle stopped and the engine idling.
      A/T Indicator Operation 2*2 A/T indicator (sequential mode) Es, 7, 6, 5 or 8 Perform the test with the vehicle stopped and the engine idling.
      A/T Indicator Operation 3*2 A/T indicator D Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Airbag SRS warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Precrash*9 PCS indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Driver Side Seat Belt Front seat belt warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp ABS ABS warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Charge CHARGE warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Slip SLIP indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Coolant Cool Engine coolant temperature COOL ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Coolant Hot Engine coolant temperature HOT ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Beam BEAM indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Tail TAIL indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Fr FOG*4 FRONT FOG indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Rr FOG*5 REAR FOG indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Fuel FUEL warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Tire Pressure Warning System*6 Tire pressure warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. ECONO*2 Eco driving indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Cruise*7 Cruise main indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Lamp Brake Brake system warning light (red indicator) ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat GLOW*10 GLOW indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. EPS EPS warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Master Warning Master warning light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. SET*7 Cruise set indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. SIL (Up)*8 SIL indicator (UP) light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. SIL (Down)*8 SIL indicator (DOWN) light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. ASL*7 Speed limiter indicator ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. Sport (CVT Sport)*2 SPORT indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Indicat. VSC OFF VSC OFF indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Automatic High Beam Indicator*11 Automatic high beam indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Stop and Start ON Indicator*3 Stop and start indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Stop and Start OFF Indicator*3 Stop and start cancel indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      LDA Control Indicator*12 Lane departure alert indicator light ON / OFF Perform the test with the vehicle stopped and the engine idling.
      Meter Display 1 All dots in multi-information display ALL Perform the test with the vehicle stopped and the engine idling.

      • *1:


        • The doors are locked automatically when performing the speedometer Active Test. This is a normal function.

        • The needle position should be within the acceptable range.

        • The displayed value has the same units (km/h, mph) as the main scale of the vehicle speedometer.

      • *2: for CVT

      • *3: w/ Stop and Start System

      • *4: w/ Front Fog Light

      • *5: w/ Rear Fog Light

      • *6: w/ Tire Pressure Warning System

      • *7: w/ Cruise Control System

      • *8: for Manual Transaxle

      • *9: w/ Pre-collision System

      • *10: for 1WW

      • *11: w/ Automatic High Beam System

      • *12: w/ Lane Departure Alert System