ROOM LIGHT(for Rear Side) INSPECTION

PROCEDURE


  1. INSPECT NO. 1 ROOM LIGHT ASSEMBLY


    1. A002PS7E01
      Text in Illustration
      *1

      Component without harness connected

      (No. 1 Room Light Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (+B) - 2 (GND) Spot light switch off 10 kΩ or higher
      Spot light switch on Below 1 Ω

      If the result is not as specified, replace the No. 1 room light assembly.