GENERATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 ENGINE COVER


    1. A002PUYE02

      Lift the No. 1 engine cover to detach the 4 clips in the order shown in the illustration and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover to break.

  4. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A002OYV

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  5. REMOVE INTAKE MANIFOLD

    Click here

  6. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  7. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  8. REMOVE FAN AND GENERATOR V BELT

    Click here

  9. REMOVE GENERATOR ASSEMBLY


    1. A002MBA

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the generator wire.

    4. A002QIXE02

      Using an E12 "TORX" socket wrench, remove the 2 bolts as shown in the illustration.

      Tech Tips

      Bolt A cannot be removed with the generator assembly installed to the vehicle.

    5. A002OIO

      Remove the generator assembly as shown in the illustration.