CHARGING SYSTEM Charging Failure

PROCEDURE


  1. CHECK LOCK FUNCTION OF GENERATOR CLUTCH PULLEY


    1. Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.

      OK
      The fan of the generator rotor assembly is operating.

    NG

    REPLACE GENERATOR PULLEY WITH CLUTCH Click here

    OK

  2. CHECK GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION)


    1. Remove the generator assembly Click here.

    2. Check the installation condition of the generator pulley cap.

      OK
      The generator pulley cap is not loose or missing.

    3. Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).

      OK
      No grease leaks (for wet pulley) or large build-up of particles (for dry pulley).

    4. Check the generator pulley with clutch for misalignment (interference with the generator assembly).

      OK
      The generator pulley with clutch is correctly aligned (no interference with the generator assembly).
    5. A002QGA

      Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.

      OK
      Noise does not occur when turned in both directions.

    6. Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.

      OK
      The generator pulley with clutch does not have runout.
    7. A002MTW

      Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

      OK
      The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

    OK

    REPAIR OR REPLACE GENERATOR ASSEMBLY Click here

    NG

    REPLACE GENERATOR PULLEY WITH CLUTCH Click here