TOYOTA PARKING ASSIST-SENSOR SYSTEM Taillight Relay Circuit

DESCRIPTION

This is the power source circuit of the clearance warning ECU.

WIRING DIAGRAM

A002PL3E02

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK TAILLIGHT


    1. Turn the light control switch to the TAIL position.

    2. Check that the taillight turns on.

      OK
      Taillight turns on.

    NG

    GO TO LIGHTING SYSTEM Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)


    1. A002PB4E01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Clearance Warning ECU)

      Disconnect the H95 clearance warning ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H95-24 (TL) - Body ground Ignition switch ON, light control switch tail or head 11 to 14 V
      Ignition switch ON, light control switch not tail or head Below 1 V

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR