REAR DOOR SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR SPEAKER ASSEMBLY

    Note

    Do not touch the cone part of the speaker.


    1. Temporarily install the speaker by attaching the claw of the speaker to the door panel.

    2. A002N47

      Using an air riveter or hand riveter, install the speaker with 3 new rivets.

      Note


      • A002MY3E62

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Mandrel
        *4 Riveter
      • A002OOTE11

        Confirm that the rivets are seated properly against the speaker.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • A002QZCE11

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

    3. Connect the connector.

  2. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  5. INSTALL REAR DOOR TRIM MOULDING LH

    Click here

  6. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  7. INSTALL REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

    Click here

  8. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.