RADIO RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)


    1. A002LT6

      Remove the 4 screws.

    2. A002NQD

      Pull the radio receiver assembly with bracket to detach the 4 clips on the backside of the radio receiver assembly with bracket.

    3. Disconnect the connectors and remove the radio receiver assembly with bracket.

  7. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)


    1. A002PCU

      Remove the 4 screws.

    2. A002NLK

      Pull the radio receiver and display receiver assembly with bracket to detach the 4 clips on the backside of the radio and display receiver assembly with bracket.

    3. Disconnect the connectors and remove the radio and display receiver assembly with bracket.

  8. REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)


    1. A002LOX

      Remove the 3 screws and No. 1 radio bracket.

  9. REMOVE NO. 1 RADIO BRACKET (for Radio and Display Type)


    1. A002P5L

      Remove the 3 screws and No. 1 radio bracket.

  10. REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)


    1. A002QC9

      Remove the 3 screws and No. 2 radio bracket.

  11. REMOVE NO. 2 RADIO BRACKET (for Radio and Display Type)


    1. A002PLX

      Remove the 3 screws and No. 2 radio bracket.