PARKING BRAKE ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL LH

  2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A002MG7

      Remove the 2 bolts and disconnect the rear disc brake cylinder.

      Note


      • Do not disconnect the flexible hose from the disc brake cylinder.

      • Do not twist or bend the flexible hose.

    2. Hang the disc brake cylinder with a piece of wire.

  3. REMOVE REAR DISC


    1. A002OZZE01
      Text in Illustration
      *1 Matchmark

      Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

    2. Remove the shoe adjusting hole plug.

    3. A002PFW

      Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  4. REMOVE PARKING BRAKE SHOE RETURN SPRING


    1. A002OU4

      Remove the 2 return springs.

  5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. A002QRQ

      Remove the shoe hold down spring cup and shoe hold down spring from the parking brake shoe.

    2. A002PGR

      Remove the parking brake shoe strut.

    3. A002PJY

      Disconnect the tension spring.

    4. A002OUZ

      Remove the No. 1 parking brake shoe and shoe adjuster screw set.

  6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. A002POQ

      Remove the shoe hold down spring cup and shoe hold down spring from the parking brake shoe.

    2. Remove the tension spring.

    3. Remove the No. 2 parking brake shoe.

  7. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A002MMK

      Using needle-nose pliers, disconnect the No. 3 parking brake cable assembly from the parking brake shoe lever as shown in the illustration.

      Note

      Be careful not to damage the No. 3 parking brake cable assembly.

  8. REMOVE NO. 1 PARKING BRAKE SHOE HOLD DOWN SPRING PIN


    1. A002QE5

      Remove the No. 1 parking brake shoe hold down spring pin.

  9. REMOVE NO. 2 PARKING BRAKE SHOE HOLD DOWN SPRING PIN


    1. A002QMK

      Remove the No. 2 parking brake shoe hold down spring pin.