REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was removed.

PROCEDURE


  1. INSTALL REAR BRAKE FLEXIBLE HOSE


    1. Install the rear brake flexible hose with a new clip.

      Note

      Make sure the clip is completely pushed in.

    2. A002O7M

      Using a union nut wrench, connect the brake line to the rear brake flexible hose while holding the rear brake flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not kink or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    3. A002LZN

      Install a new rear flexible hose gasket and connect the rear brake flexible hose to the rear disc brake cylinder assembly with a new union bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

      Tech Tips

      Insert the flexible hose lock securely into the lock hole in the disc brake cylinder.

  2. REMOVE CENTER COWL TOP VENTILATOR LOUVER

    Click here

  3. BLEED BRAKE LINE

    Click here

  4. BLEED AIR FROM CLUTCH LINE (for 1ZR-FAE with Manual Transaxle)

    Click here

  5. BLEED AIR FROM CLUTCH LINE (for 2ZR-FAE with Manual Transaxle)

    Click here

  6. BLEED CLUTCH LINE (for 1WW)

    Click here

  7. INSTALL CENTER COWL TOP VENTILATOR LOUVER

    Click here

  8. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }