REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    1. w/o Rear No. 2 Seat:

      Remove the deck trim side panel assembly LH Click here.

    2. w/ Rear No. 2 Seat:

      Remove the deck trim side panel assembly LH Click here.

  3. REMOVE REAR WHEEL

  4. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  5. REMOVE REAR DISC

    Click here

  6. REMOVE SKID CONTROL SENSOR WIRE


    1. Disconnect the skid control sensor wire connector from the vehicle side connector on the rear floor.

    2. A002PTI

      Detach the grommet of the skid control sensor wire from the hole of the wheel house.

    3. A002OFM

      Remove the nut and sensor clamp from the wheel house gusset.

    4. A002QMR

      Remove the nut and sensor clamp from the bracket.

    5. A002LS5

      Detach the 2 grommets.

    6. Disconnect the connector.

  7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)


    1. Remove the rear axle hub and bearing LH Click here.