FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. A002QJNE01

      Using an 8 mm hexagon wrench, install SST (A) to the crankshaft.

      SST
      PZ4TB-04961-27

    2. Set a new timing gear case or timing chain case oil seal to the cylinder block.

    3. A002Q7NE01

      Install SST (B) to SST (A).

      SST
      PZ4TB-04961-27
    4. A002O6QE01

      Install and tighten SST (C) to install the timing gear case or timing chain case oil seal to the crankshaft.

      SST
      PZ4TB-04961-27

      Tech Tips

      Tighten SST (C) until SST (B) contacts the cylinder block.

    5. Remove SST (C), SST (B) and SST (A).

  2. INSTALL CRANKSHAFT PULLEY


    1. A002NX4E03

      Using SST, hold the flywheel sub-assembly.

      SST
      PZ4TB-04951-26

    2. Install the crankshaft pulley to the crankshaft with 4 new bolts.

      Tech Tips

      The crankshaft pulley bolts are tightened in 2 progressive steps.

    3. Step 1:


      1. Using an E10 "TORX" socket wrench, tighten the 4 bolts.

        Torque:
        40 N*m  { 408 kgf*cm, 30 ft.*lbf }

    4. Step 2:


      1. Mark the RH side of the each crankshaft pulley bolt with paint.

      2. Tighten the bolts 120°.

      3. Check that the paint marks are now at a 120° angle to the RH side.

    5. Remove SST.

    6. Install the plug to the cylinder block.

  3. INSTALL FAN AND GENERATOR V BELT

    Click here