FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. A002O21E01

      Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. A002QNTE04
      Text in Illustration
      *1 Hold
      *2 Turn

      Align the key groove of the pulley with the pulley set key.

    2. Temporarily install the pulley with the pulley bolt.

    3. Using SST, hold the pulley in place and tighten the bolt.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      09330-00021
      Torque:
      190 N*m  { 1940 kgf*cm, 140 ft.*lbf }

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSPECT V-RIBBED BELT

    Click here

  5. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  6. ADD ENGINE OIL

    Click here

  7. INSPECT FOR ENGINE OIL LEAK

    Click here

  8. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  9. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  10. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  11. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here