AIR FUEL RATIO SENSOR(for Sensor 2) INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A002QJAE01
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00011
      Torque:
      without SST
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }
      with SST
      45 N*m  { 463 kgf*cm, 33 ft.*lbf }

      Note

      If an air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

      • Make sure SST and the wrench are connected in a straight line.

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor Click here.

    2. Attach the 2 clamps.

    3. A002MUKE02
      Text in Illustration
      *1 Air Fuel Ratio Sensor
      *2 Bracket
      *a 1.5 mm (0.0591 in.) or less

      Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  4. PERFORM AIR FUEL RATIO SENSOR INITIALIZATION

    Click here