THROTTLE BODY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Perform "Inspection After Repairs" after replacing the throttle body assembly Click here.

PROCEDURE


  1. INSTALL THROTTLE BODY ASSEMBLY

    Tech Tips

    Perform "Inspection After Repairs" after replacing the throttle body assembly Click here.


    1. Install a new gasket to the intake manifold.

    2. A002MQOE01
      Text in Illustration
      *a for Type A
      *b for Type B

      for Type A:

      Install the throttle body with the 2 bolts and 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. for Type B:

      Install the throttle body with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    4. A002PJW

      Connect the throttle body connector and 2 water hoses.

  2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A002PZF

      Connect the air cleaner cap with the band.

    2. Connect the PCV hose.

    3. A002LW7

      Connect the 2 clamps.

    4. A002OZC

      Attach the 2 clamps and connect the wire harness.

    5. Connect the mass air flow meter connector.

  3. INSTALL NO. 2 CYLINDER HEAD COVER


    1. A002OGM

      Attach the 4 clips to install the cover.

      Note


      • Be sure to attach the clips securely.

      • Do not apply excessive force or hit the cover to attach the clips. This may cause the cover to break.

  4. ADD ENGINE COOLANT

    Click here

  5. INSPECT FOR COOLANT LEAK

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  8. PERFORM INITIALIZATION

    Note

    Perform the following procedure after replacing the throttle body assembly or any throttle body assembly components. The following procedure should also be performed if the throttle body assembly is cleaned.


    1. Turn the ignition switch to ON without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

    2. Connect the intelligent tester to the DLC3 and clear the DTCs Click here.

    3. Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

      Standard idle speed
      580 to 680 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in neutral.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

    5. Perform a road test and confirm that there are no abnormalities.