BODY GENERAL MAINTENANCE

PROCEDURE

1. INSPECT TIRE AND INFLATION PRESSURE

   
   

   1. Check the tires for wear and proper inflation pressure Click here.

2. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY

   
   

   1. Where necessary, tighten all the parts of the chassis.

      
      

      • Front axle and suspension

      • Drivetrain

      • Rear axle and suspension

      • Brake system

      • Engine mounting, etc.

   2. Where necessary, tighten all parts of the body.

      
      

      • Seat belt system

      • Seat

      • Doors and hood

      • Body mounting

      • Fuel tank

      • Exhaust pipe system, etc.

3. INSPECT LIGHTS, HORNS, WIPERS AND WASHERS

4. CLEAN OR REPLACE AIR CONDITIONING FILTER

   
   

   1. Remove the glove compartment door assembly.

   2. Remove the air filter case Click here.

   3. Remove the clean air filter Click here.

   4. Visually inspect the surface of the clean air filter.

   5. If the clean air filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.

      Note

      Some filters are not able to be cleaned.

5. FINAL INSPECTION

   
   

   1. Check the operation of the body parts.

      
      

      1. Hood

         
         

         • Auxiliary catch operates properly.

         • Hood locks securely when closed.

      2. Front and rear doors

         
         

         • Door locks operate properly.

         • Doors close properly.

      3. Back door

         
         

         • Door lock operates properly.

         • Door closes properly.

      4. Seats

         
         

         • Seat adjusts easily and locks securely in any position.

         • Front seatback locks securely in any position.

         • Rear seatback locks securely in any position.

         • Folding-down rear seatbacks lock securely.

      5. Be sure to deliver a clean vehicle. Especially check:

         
         

         • Steering wheel

         • Shift lever knob

         • All switch knobs

         • Door handles

         • Seats

6. CORROSION INSPECTION

7. INSPECT REFRIGERANT AMOUNT OF AIR CONDITIONER

   Type	See procedures
   HFC-134a (R134a)	Click here
   HFO-1234yf (R1234yf)	Click here