REAR AXLE HUB INSTALLATION

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH


    1. A002QFU

      Install the rear axle hub and bearing assembly with the 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

  2. CONNECT SKID CONTROL SENSOR WIRE


    1. A002QF1

      Connect the skid control sensor wire connector to the skid control sensor.

      Note

      Do not twist the sensor wire when installing the clamp.

  3. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  4. INSPECT REAR AXLE HUB RUNOUT

    Click here

  5. INSTALL REAR DISC

    Click here

  6. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  7. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  8. INSPECT REAR WHEEL ALIGNMENT


    1. Inspect the rear wheel alignment Click here.

  9. CHECK SPEED SENSOR SIGNAL

    Click here