FRONT DRIVE SHAFT ASSEMBLY(for 1ZR-FAE, 2ZR-FAE) INSPECTION

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT


    1. A002Q6F

      Check that there is no severe play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 boots for damage.

    5. A002M8EE18

      Check that the 2 boots are not stretched or contracted when the drive shaft is at the standard length.

      Length (A) (for LH Side)
      Engine Type Transaxle Type Specified Condition
      1ZR-FAE Manual transaxle 589.25 mm (1.93 ft.)
      2ZR-FAE Continuously variable transaxle
      Manual transaxle 590.4 mm (1.94 ft.)

      If the boots are stretched or contracted, correct them.

      Length (A) (for RH Side)
      Engine Type Transaxle Type Specified Condition
      1ZR-FAE Manual transaxle 875.25 mm (2.87 ft.)
      2ZR-FAE Continuously variable transaxle
      Manual transaxle 869.3 mm (2.85 ft.)

      If the boots are stretched or contracted, correct them.