FRONT DRIVE SHAFT ASSEMBLY(for 1WW) INSPECTION

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. A002Q6F

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 joint boots for damage.

    5. A002NBNE02
      Text in Illustration
      *A for LH Side
      *B for RH Side

      Check that the 2 joint boots are not stretched or contracted when the front drive shaft assembly is at the standard length.

      Length (A)
      Item Specified Condition
      for LH side 558.8 mm (1.83 ft.)
      for RH side 906.3 mm (2.97 ft.)

      Note

      Keep the front drive shaft assembly level during inspection.

      If the boots are stretched or contracted, correct them.