MANUAL TRANSAXLE UNIT INSPECTION

PROCEDURE


  1. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY


    1. A002MAH

      Using a caliper gauge, measure the inside diameter of the reverse idler gear.

      Standard inside diameter
      25.056 to 25.074 mm (0.9864 to 0.9871 in.)
      Maximum inside diameter
      25.074 mm (0.9871 in.)

      If the inside diameter is more than the maximum, replace the reverse idler gear sub-assembly.

    2. Using a micrometer, measure the outer diameter of the reverse idler gear shaft.

      Standard outer diameter
      24.984 to 25.000 mm (0.9836 to 0.9842 in.)
      Minimum outer diameter
      24.984 mm (0.9836 in.)

      If the outer diameter is less than the minimum, replace the reverse idler gear shaft.