TRANSMISSION CONTROL CABLE ADJUSTMENT

PROCEDURE


  1. ADJUST CONTROL SELECT CABLE

    Tech Tips


    • After the shift lever or transmission control cable assembly is replaced, be sure to adjust the control select cable.

    • If the shift lever cannot be moved (or the shift lever is difficult to move) to 1 or 2, or if it is possible to move the shift lever to R without pulling up the slider shaft, the length of the cable must be adjusted.


    1. A002LS6E05
      Text in Illustration
      *1 Select Cable

      Pinch the areas indicated by the arrows and disconnect the control select cable.

    2. Release the lock of the cable length adjustment structure of the select cable.


      1. A002PC9E02
        *1 Stopper
        *2 Turn

        Turn the stopper.

      2. A002N6CE05
        *1 Lock Piece
        *2 Pull out
        *3 Case

        Pull the lock piece outward from the case to release the lock.

      3. A002LQ3E04
        *1 Stopper
        *2 Return

        Return the stopper.

    3. A002MABE03
      Text in Illustration
      *1 Reverse Restrict Pin Assembly
      *2 Outer Lever

      w/ Reverse Restrict Pin Assembly:

      Hook the outer lever of the manual transaxle onto the reverse restrict pin assembly to secure it.

    4. A002NS5C01
      *1 Outer Lever
      *a Installation hole for transmission control select cable adjustment
      *b Cutout

      w/o Reverse Restrict Pin Assembly:

      Align the outer lever cutout with the hole for adjusting the transmission control select cable, and insert the bolt by hand to secure the outer lever as shown in the illustration.

      Note

      In order to avoid case damage, do not push the bolt in forcefully.

      Tech Tips


      • Use a bolt with a diameter of 6.0 mm (0.236 in.) and a length of at least 18 mm (0.709 in.) or more.

      • Depending on the actual bolt diameter, it may be difficult to insert the bolt. In that case, as there is some variation in actual bolt diameters, use a 6.0 mm (0.236 in.) bolt with a comparatively small diameter.

    5. A002PHHE02

      Connect the control select cable to the shift lever assembly.

    6. Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    7. Lock the cable length adjustment structure of the select cable.


      1. Turn the stopper.*1

      2. Push the lock piece into the case.*2

      3. Return the stopper to prevent the lock from being released.*3

        Note


        • Push the lock piece as far as it will go.

        • Confirm whether the cable length adjustment structure is locked securely.

    8. A002P7ME03
      *1 Reverse Restrict Pin Assembly
      *2 Outer Lever
      *3 Release

      w/ Reverse Restrict Pin Assembly:

      Move the shift lever to R to release the outer lever.

    9. A002Q55

      w/o Reverse Restrict Pin Assembly:

      Pull out the bolt to free the outer lever.