TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the front exhaust pipe assembly Click here.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY

  8. REMOVE BATTERY TRAY

  9. REMOVE BATTERY CARRIER

    Click here

  10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  11. REMOVE AIR CLEANER CASE

    Click here

  12. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  13. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    A002QD0

    1. Remove the 3 nuts and front No. 1 floor heat insulator.

  14. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A002LS6E04
      Text in Illustration
      *1 Select Cable
      *2 Shift Cable

      Disconnect the control shift cable from the shift lever assembly.

    2. Pinch the areas indicated by the arrows and disconnect the control select cable.

    3. A002O6N

      Detach the 2 claws and disconnect the control cable assembly.

    4. A002MSS

      Remove the 2 clips and disconnect the 2 cables from the transaxle.

    5. A002M8B

      Remove the 2 clips and disconnect the 2 cables from the control cable bracket.

    6. A002ORS

      Remove the bolt and detach the bracket of the control cable assembly.

    7. A002QIO

      Remove the 2 nuts and detach the grommet of the control cable assembly.