MANUAL TRANSAXLE OIL REPLACEMENT

PROCEDURE


  1. REMOVE ENGINE UNDER COVER


    1. A002OPR

      Remove the 9 clips and fold back the engine under cover.

      Tech Tips

      It is not necessary to fully remove the engine under cover. Partially remove it so that the oil can be replaced in a later step.

  2. DRAIN MANUAL TRANSAXLE OIL


    1. A002PCVE05
      Text in Illustration
      *1 Filler Plug
      *2 Drain Plug

      Remove the filler plug and gasket.

    2. Remove the drain plug and gasket to drain the manual transaxle oil.

    3. Install a new gasket and the drain plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

  3. ADD MANUAL TRANSAXLE OIL


    1. Add manual transaxle oil.

      Manual Transaxle Oil
      "Toyota Genuine Manual Transmission Gear Oil LV" or "API GL-4 and SAE 75W"
      Capacity (Reference)
      2.1 liters (2.2 US qts, 1.8 Imp. qts)
    2. A002PIYE87
      Text in Illustration
      *a 0 to 5 mm (0 to 0.196 in.)

      Check that the oil surface is within 5 mm (0.196 in.) of the bottom of the manual transmission filler plug opening.

    3. Install a new gasket and the transmission filler plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Note


      • When adding transaxle oil, make sure the vehicle is level.

      • An excessively large or small amount of oil may cause problems.

      • After adding oil, drive the vehicle and recheck the oil level.

  4. INSPECT FOR OIL LEAK

  5. INSTALL ENGINE UNDER COVER


    1. A002MWW

      Install the engine under cover with the 9 clips.