TRANSMISSION CONTROL CABLE ADJUSTMENT

PROCEDURE


  1. ADJUST CONTROL SELECT CABLE

    Tech Tips


    • After the shift lever or transmission control cable assembly is replaced, be sure to adjust the control select cable.

    • If the shift lever cannot be moved (or the shift lever is difficult to move) to 1 or 2, or if it is possible to move the shift lever to R without pulling up the slider shaft, the length of the cable must be adjusted.


    1. A002LS6E05
      Text in Illustration
      *1 Control Select Cable

      Pinch the areas indicated by the arrows and disconnect the control select cable.

    2. Release the lock of the cable length adjustment structure of the select cable.


      1. A002PC9E04
        Text in Illustration
        *1 Stopper
        *a 34°
        *b Turn

        Turn the stopper.

      2. A002N6CE04
        Text in Illustration
        *1 Lock Piece
        *2 Case
        *a Pull Out

        Pull the lock piece outward from the case to release the lock.

      3. A002LQ3E03
        Text in Illustration
        *1 Stopper
        A002OPC Return

        Return the stopper.

    3. A002OZNE02

      While pressing the shift and select lever shaft (*1) and pin (*2), push in the pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.315 in.) below the N position).

    4. Connect the control select cable to the shift lever assembly.

    5. A002PHHE01
      Text in Illustration
      *1 Slider
      *2 Inhibitor Wall
      *3 Stopper
      *4 Lock Piece
      *a Turn
      *b Return
      *c Push
      *d Press with a force of 20 N*m (204 kgf*cm, 15 ft.*lbf)

      Push the slider against the inhibitor wall.

      Note


      • Press the slider against the inhibitor wall with a force of 20 N*m (204 kgf*cm, 15 ft.*lbf) as shown in the illustration.

      • Keep pressing the slider against the inhibitor wall until the cable adjustment is completed.

      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    6. Lock the cable length adjustment structure of the select cable.


      1. Turn the stopper.

      2. Push the lock piece into the case.

        Note

        Do not move the cable in the axial direction.

      3. Return the stopper to prevent the lock from being released.

        Note


        • Push the lock piece as far as it will go.

        • Confirm whether the cable length adjustment structure is locked securely.

    7. A002P4S

      Release the pin that fixes the shift and select lever shaft.

      Text in Illustration
      A002OPC Pull

      1. Pull the pin toward the left front side of the vehicle.