EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A002NGW

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum Free Length
      41.5 mm (1.63 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. A002QYUE30
      Text in Illustration
      *1 Gasket
      *2 Wooden Block

      Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the exhaust pipe, do not push in the gasket with the exhaust pipe.

    3. A002PQS

      Install the 3 exhaust pipe supports, and then install the front exhaust pipe assembly with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  2. INSTALL HEATED OXYGEN SENSOR

    Click here

  3. INSTALL NO. 2 ENGINE UNDER COVER


    1. A002NMG

      Install the under cover with the 4 clips.

  4. INSTALL FRONT FLOOR CENTER BRACE

    A002O9L

    1. Install the floor brace with the 4 bolts.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }

  5. INSTALL TAILPIPE ASSEMBLY


    1. A002NGW

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum Free Length
      38.5 mm (1.52 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. A002QYUE30
      Text in Illustration
      *1 Gasket
      *2 Wooden Block

      Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the front exhaust pipe assembly.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the exhaust pipe, do not push in the gasket with the exhaust pipe.

    3. A002OO8

      Install the 2 exhaust pipe supports, and then install the tailpipe assembly with the 2 compression springs and 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  6. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.