MONOLITHIC CONVERTER REMOVAL

PROCEDURE


  1. REMOVE AIR FUEL RATIO SENSOR


  2. REMOVE EXHAUST GAS TEMPERATURE SENSOR


  3. REMOVE DIFFERENTIAL PRESSURE SENSOR

    Click here

  4. REMOVE HEATER WITH EXHAUST PIPE ASSEMBLY (w/ Combustion Type Power Heater)

    Click here

  5. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

    Click here

  6. REMOVE OUTER COWL TOP PANEL

    Click here

  7. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  8. REMOVE FRONT FLOOR CENTER BRACE

    Click here

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the 4 bolts and 4 compression springs.

    2. Disconnect the front exhaust pipe assembly from the 3 exhaust pipe supports.

    3. Remove the 2 gaskets.

  10. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A002MWE

      Detach the 2 clamps and disconnect the engine wire.

    2. Remove the 2 bolts and No. 1 exhaust manifold heat insulator.

  11. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    1. A002QU7

      Remove the 2 bolts, 2 nuts and manifold stay.

    2. A002MQ9

      Loosen the V-band clamp.

    3. Remove the 3 nuts, 3 bolts, V-band clamp, gasket, engine bracket and exhaust manifold converter sub-assembly.

      A002NC1E02
      Text in Illustration
      *1 Engine Bracket *2 Exhaust Manifold Converter Sub-assembly
      *3 No. 2 Manifold Stay - -