INTAKE MANIFOLD REMOVAL

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE GENERATOR ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE THROTTLE BODY ASSEMBLY

    Click here

  5. REMOVE VACUUM SENSOR ASSEMBLY

    A002N6L

    1. Disconnect the vacuum sensor connector.

    2. Remove the engine cover joint and vacuum sensor assembly.

    3. Disconnect the air hose from the vacuum sensor assembly.

  6. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

    A002O9I

    1. Disconnect the connector and 2 vacuum hoses.

    2. Remove the bolt and No. 1 vacuum switching valve assembly.

  7. REMOVE INTAKE MANIFOLD


    1. A002QYK

      Remove the bolt and wire harness clamp bracket.

    2. Detach the 5 clamps and wire harness from the intake manifold.

    3. A002LR4

      Disconnect the fuel vapor feed hose and ventilation hose.

    4. A002PR4

      Remove the 5 bolts, 2 nuts, intake manifold stay and intake manifold.

    5. A002MEM

      Remove the gasket from the intake manifold.

    6. A002QDD

      Remove the bolt and wire harness clamp bracket from the intake manifold.

    7. w/ Stud Bolt:

      Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.

  8. REMOVE NO. 1 GAS FILTER

    A002N4L

    1. Disconnect the air hose from the No. 1 gas filter and intake manifold.

    2. Using a 24 mm deep socket wrench, remove the No. 1 gas filter from the intake manifold.

  9. REMOVE ENGINE COVER JOINT


    1. Remove the engine cover joint.