SHIFT LEVER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL SHIFT LEVER ASSEMBLY

    Note

    Check that the park/neutral position switch and shift lever are in neutral.


    1. Install the shift lever assembly with the 4 nuts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Connect the 2 connectors and attach the 2 clamps to connect the wire harness to the shift lever.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Turn the nut of the transmission control cable assembly 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

      A002MMVE20
      Text in Illustration
      *1 Stopper *2 Nut
      *a Push in - -

    2. Install the outer part of the transmission control cable assembly to the shift lever assembly. Check that the spring is positioned at "A" and push in the stopper.

      A002O40E07
      Text in Illustration
      *1 Stopper *2 Nut
      *3 Shift Lever Assembly *4 Spring

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    3. A002NOSE02
      Text in Illustration
      *1 Lock Piece
      *a Side View
      *b Bottom View
      *c Push

      Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.

    4. A002NXLE03
      Text in Illustration
      *1 Lock Piece
      A002OPC MP grease

      Coat the end of the transmission control cable assembly with MP grease.

    5. Connect the end of the transmission control cable assembly to the shift lever assembly.

      Note


      • Make sure that the lock piece is pulled up.

      • Push on the end of the transmission control cable assembly all the way to the base of the pin.

    6. A002LXQE01
      Text in Illustration
      *1 Lock Piece
      *2 Adjuster Case
      *a Push in

      Push the lock piece into the adjuster case.

      Note

      Securely push in the lock piece until it locks.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. ADJUST SHIFT LEVER POSITION

    Click here

  5. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here