TRANSMISSION CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. REMOVE FRONT FLOOR CENTER BRACE

    Click here

  6. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  7. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR


    1. A002NWF

      Disconnect the connector.

    2. Detach the clamp.

  8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  9. REMOVE FRONT FLOOR NO. 2 HEAT INSULATOR


    1. A002PLB

      Remove the 3 nuts and heat insulator.

  10. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR


    1. A002OE6

      Remove the 3 nuts and heat insulator.

  11. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A002OIP

      Disconnect the end of the transmission control cable assembly from the shift lever assembly.

    3. A002N5LE06
      Text in Illustration
      *1 Stopper
      *2 Nut

      Pull out the stopper of the transmission control cable assembly.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    5. A002NFN

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable from the control cable bracket.

    7. A002MSI

      Remove the bolt and disconnect the transmission control cable clamp from the rear engine mounting insulator.

    8. A002NXT

      Remove the 2 nuts and disconnect the transmission control cable assembly.

    9. Pull out the transmission control cable assembly to remove it.

  13. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET


    1. A002O11

      Detach the clamp.

    2. A002PIZ

      Remove the 2 bolts and No. 1 transmission control cable bracket from the continuously variable transaxle assembly.