OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENSOR


    1. Apply Toyota Genuine CVT Fluid FE to the O-ring.

      Note

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

    2. A002P4NE03
      Text in Illustration
      *a SST Fulcrum Length
      *b Torque Wrench Fulcrum Length

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      SST
      09326-22011
      Torque:
      Specified tightening torque
      21 N*m  { 210 kgf*cm, 15 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using SST (fulcrum length of 50 mm (1.9685 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 16 N*m (164 kgf*cm, 12 ft.*lbf).

    3. Connect the oil pressure sensor connector.

  2. INSPECT FOR FLUID LEAK

  3. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  4. INSTALL FRONT WHEEL LH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. RESET MEMORY

    Click here