REVOLUTION SENSOR INSPECTION

PROCEDURE


  1. INSPECT TRANSMISSION REVOLUTION SENSOR (NIN)


    1. A002Q16E02
      Text in Illustration
      *a

      Component without harness connected

      (Transmission Revolution Sensor (NIN))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (NIN-) - 2 (NIN +) 20°C (68°F) 560 to 680 Ω

      • If the result is not as specified, replace the transmission revolution sensor (NIN).

  2. INSPECT TRANSMISSION REVOLUTION SENSOR (NOUT)


    1. Wave a magnetic object left and right in front of the transmission revolution sensor (NOUT) tip (5 mm (0.197 in.) or less) to change the high/low signals while measuring the current.

      A002ONRE19
      Text in Illustration
      *1 Battery - -
      *a

      Component without harness connected

      (Transmission Revolution Sensor (NOUT))

      		 *b Magnet
      *c 5 mm (0.197 in.) or less *d Ammeter

      Note

      Make sure to wave the magnetic object during the inspection. Current will not change without waving the magnetic object as indicated by the arrow in the illustration.

    2. Measure the current according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (NOTO) - 2 (NOTB) Low signal 4 to 8 mA
      High signal 12 to 16 mA

      • If the result is not as specified, replace the transmission revolution sensor (NOUT).