WIPER SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the auto away/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing this operation.

      Tech Tips

      Performing the above operation disables the auto away/return function when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off and disconnect the cable from the auxiliary battery negative (-) terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER STEERING COLUMN COVER

    Click here

  4. REMOVE TILT AND TELESCOPIC MANUAL SWITCH (for RHD)

    Click here

  5. REMOVE UPPER STEERING COLUMN COVER

    Click here

  6. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. B0018JN

      Disconnect the 2 connectors.

    2. B0019VDE01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver wrapped with protective tape, detach the claw and remove the windshield wiper switch assembly.

      Note

      If the claw is pushed with excessive force, it may be broken.