POWER BACK DOOR TOUCH SENSOR INSPECTION

PROCEDURE


  1. INSPECT POWER BACK DOOR SENSOR ASSEMBLY LH


    1. A01WWSUE06
      *1 Component without harness connected: (Power Back Door Sensor Assembly LH)
      *2 Pressed
      *3 Not pressed

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1(OSL) - 2(OSLE) Not pressed Approximately 1 kΩ
      Pressed Below 100 Ω

      If the result is not as specified, replace the power back door sensor assembly LH.

  2. REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH


    1. A01WWSUE07
      *1 Component without harness connected: (Power Back Door Sensor Assembly RH)
      *2 Pressed
      *3 Not pressed

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1(OSR) - 2(OSRE) Not pressed Approximately 1 kΩ
      Pressed Below 100 Ω

      If the result is not as specified, replace the power back door sensor assembly RH.