TAIL GATE CLOSER SYSTEM, Diagnostic DTC:B225C

DTC Code DTC Name
B225C Tail Gate Panel Position Switch LH

DESCRIPTION

The No. 2 main body ECU receives the close position switch signal from the lower tail gate lock assembly LH and detects the open/closed status of the lower tail gate. DTC B225C is stored when the No. 2 main body ECU receives a close position switch malfunction signal from the lower tail gate lock assembly LH.

DTC Code DTC Detection Condition Trouble Area
B225C A close position switch malfunction (open or short circuit) signal from the lower tail gate lock LH is received.

  • Lower tail gate lock assembly LH

  • Harness or connector

  • No. 2 main body ECU

WIRING DIAGRAM

B001A8LE14
*1 LMT
*2 HND
*3 Lower Tail Gate Lock Assembly LH (Close Position Switch)
*4 No. 2 Main Body ECU

PROCEDURE


  1. READ VALUE USING GTS (POSITION SWITCH LH)


    1. Check the Data List for proper functioning of the close position switch Click here.

      Body No. 4
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Position Switch LH Close position switch LH signal / ON or OFF

      ON: Lower tail gate closed

      OFF: Lower tail gate open

      		 -
      OK
      The display is as specified in the normal condition.

    NG

    INSPECT LOWER TAIL GATE LOCK ASSEMBLY LH Click here

    OK

  2. CHECK DTC OUTPUT


    1. Starting with the lower tail gate closed, open and close the lower tail gate 6 times.

    2. Check for DTCs Click here.

    3. Clear the DTCs Click here.

    4. Starting with the lower tail gate closed, open and close the lower tail gate 6 times.

    5. Recheck for DTCs Click here.

      OK
      DTC B225C is not output.

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

    REPLACE NO. 2 MAIN BODY ECU Click here

  3. INSPECT LOWER TAIL GATE LOCK ASSEMBLY LH


    1. Remove the lower tail gate lock assembly LH Click here.

    2. Inspect the lower tail gate lock assembly LH Click here.


    NG

    REPLACE LOWER TAIL GATE LOCK ASSEMBLY LH Click here

    OK

  4. CHECK HARNESS AND CONNECTOR (LOWER TAIL GATE LOCK ASSEMBLY LH - NO. 2 MAIN BODY ECU AND BODY GROUND)


    1. Disconnect the f3 lower tail gate lock assembly LH connector.

    2. Disconnect the L34 No. 2 main body ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      f3-7 (HND) - L34-10 (LMT) Always Below 1 Ω
      f3-8 (GND) - Body ground Always Below 1 Ω
      f3-7 (HND) - Body ground Always 10 kΩ or higher

    OK

    REPLACE NO. 2 MAIN BODY ECU Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR