POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. B0018R8

      Apply MP grease to the sliding and rotating areas of the regulator motor.

    2. Using a T25 "TORX" driver, install the power window regulator motor assembly LH with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  5. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR GLASS RUN LH

    Click here

  7. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  8. INSTALL REAR SPEAKER SET

    Click here

  9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  12. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  13. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  14. INSTALL REAR DOOR TRIM COVER

    Click here

  15. INSTALL REAR DOOR UPPER ARMREST BASE PANEL LH

    Click here

  16. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  18. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here