POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. B001AK4

      Apply MP grease to the sliding and rotating areas of the regulator motor.

    2. Using a T25 "TORX" driver, install the power window regulator motor assembly LH with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  5. INSTALL SIDE AIR BAG SENSOR ASSEMBLY LH

    Click here

  6. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  7. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  10. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  11. INSTALL FRONT UPPER ARMREST BASE PANEL LH

    Click here

  12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  13. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here