POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  5. REMOVE FRONT UPPER ARMREST BASE PANEL LH

    Click here

  6. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  7. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  10. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  11. REMOVE SIDE AIR BAG SENSOR ASSEMBLY LH

    Click here

  12. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  14. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  15. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. B001AK4

      Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.

      Note

      Be careful when removing the screws as the motor may fall and become damaged.