FRONT PASSENGER SIDE POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A01WQ3CE12
      Text in Illustration
      *a

      Component without harness connected

      (Power Window Regulator Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition

      2 (UP) - 5 (GND)

      2 (UP) - 4 (AUTO)

      		 Auto up operation Below 1 Ω
      2 (UP) - 5 (GND) Manual up operation Below 1 Ω
      5 (GND) - 10 (DOWN) Manual down operation Below 1 Ω

      5 (GND) - 10 (DOWN)

      4 (AUTO) - 10 (DOWN)

      		 Auto down operation Below 1 Ω

      • If the result is not as specified, replace the power window regulator switch assembly.

    2. A01WQ3CE09
      Text in Illustration
      *a

      Component without harness connected

      (Power Window Regulator Switch Assembly)

      Check that the LED illuminates.


      1. Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (ILL+)

        Battery negative (-) → 6 (ILL-)

        		 LED illuminates

        • If the result is not as specified, replace the power window regulator switch assembly.