FRONT CONSOLE BOX(w/ Cool Box) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL COOLING BOX ASSEMBLY

    B00182W

    1. Attach the 2 claws.

    2. Connect the connector.

    3. Sufficiently apply compressor oil to 2 new O-rings.

      Compressor oil
      ND-OIL 8 or equivalent

    4. Install the 2 O-rings to the 2 cooler pipes.

    5. Connect the 2 cooler pipes with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    6. Install the cooling box assembly with the 4 bolts and 2 screws.

  2. INSTALL TELEMATICS TRANSCEIVER (w/ Telematics Transceiver)

    Click here

  3. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 1 COOLER COVER


    1. B0018NV

      Attach the claw on the upper part of the No. 1 cooler cover, and then attach the clamp on the lower part of the cooler cover to install it.

  5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  6. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  9. INSTALL UPPER CONSOLE BOX

    Click here

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  11. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    Click here

  12. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  13. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  14. CHARGE REFRIGERANT

    Click here

  15. WARM UP ENGINE

    Click here

  16. CHECK FOR REFRIGERANT GAS LEAK

    Click here

  17. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here