VOLTAGE INVERTER ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT VOLTAGE INVERTER ASSEMBLY

    Tech Tips

    Remove interior parts so that the voltage inverter can be seen.


    1. A01WTKPE03
      *1 Front view of wire harness connector: (to Voltage Inverter)

      Disconnect the voltage inverter connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K16-1 (IG) - K16-4 (GND) Engine switch on (IG) 10 to 16 V

      GND (K16-4) - Body ground

      K16-4 (GND) - Body ground

      		 Always Below 1 V

      If the result is not as specified, repair or replace the harness or connector.

    3. A01WRJUE02
      *1 Component with harness connected: (Voltage Inverter)

      Reconnect the voltage inverter connector.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K16-3 (AC1) - K16-7 (AC2)

      Engine switch on (IG)

      Main switch on

      		 AC 115 V

      If the result is not as specified, replace the voltage inverter.