VISCOUS HEATER MAGNET CLUTCH(w/ Viscous Heater) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  7. DRAIN ENGINE COOLANT

    Click here

  8. REMOVE NO. 3 ENGINE ROOM WIRE

    Click here

  9. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  11. REMOVE NO. 1 AIR CLEANER HOSE

    Click here

  12. REMOVE INTAKE AIR CONNECTOR

    Click here

  13. REMOVE V-RIBBED BELT

    Click here

  14. REMOVE VANE PUMP OIL RESERVOIR ASSEMBLY

    Click here

  15. REMOVE VANE PUMP ASSEMBLY

    Click here

  16. REMOVE NO. 1 RADIATOR HOSE

  17. REMOVE NO. 2 RADIATOR HOSE

  18. REMOVE OIL COOLER HOSE

    Click here

  19. REMOVE FAN SHROUD WITH FAN

    Click here

  20. REMOVE RADIATOR RESERVE TANK ASSEMBLY

    Click here

  21. REMOVE RADIATOR ASSEMBLY

    Click here

  22. REMOVE IDLER PULLEY ASSEMBLY

    B0019TV

    1. Remove the 2 bolts and 2 idler pulleys.

  23. REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY

    B001A22

    1. Disconnect the connector and detach the clamp.

    2. Using pliers, grip the claws of the clips and slide the 2 clips.

    3. Disconnect the 2 heater hoses.

    4. Remove the 2 bolts and heater assembly.

  24. REMOVE IDLER PULLEY BRACKET

    B0018W7

    1. Remove the bolt and bracket.

  25. REMOVE IDLER PULLEY BRACKET (for Belt Tension Side)

    B001AH4

    1. Remove the 3 bolts and bracket.