DUCT TEMPERATURE SENSOR REMOVAL

PROCEDURE

1. REMOVE UPPER RADIATOR SUPPORT SEAL

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH

   Click here

4. REMOVE REAR NO. 1 SEAT ASSEMBLY RH

   Click here

5. REMOVE REAR NO. 2 SEAT ASSEMBLY LH

   Click here

6. REMOVE REAR NO. 2 SEAT ASSEMBLY RH

   Click here

7. REMOVE REAR STEP COVER

   Click here

8. REMOVE REAR DOOR SCUFF PLATE LH

   Click here

9. REMOVE REAR DOOR SCUFF PLATE RH

   Click here

10. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    Click here

13. REMOVE REAR NO. 1 SEAT PROTECTOR

    Click here

14. REMOVE REAR NO. 2 SEAT PROTECTOR

    Click here

15. REMOVE FRONT FLOOR CARPET ASSEMBLY

    

    
    

    1. Remove the 2 clips.

    2. Fold back the floor carpet.

       Tech Tips

       Fold back the carpet until it is possible to remove the rear No. 6 air duct.

16. REMOVE REAR NO. 6 AIR DUCT

    
    

    1. Disconnect the 2 connectors.

    2. Remove the 5 screws and duct.

       

17. REMOVE DUCT TEMPERATURE SENSOR

    
    

    1. Detach the 4 claws and remove the 2 sensors.