FRONT EVAPORATOR TEMPERATURE SENSOR REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR

    B001A4ZE03

    Note

    If reusing the evaporator, do not insert the sensor at a location where the sensor was previously inserted.


    1. Insert the sensor at a location that is 1 fin to the right or left of its previous location.

      Standard Dimension
      Area Specified Condition
      a 50 mm (1.97 in.)
      b 34.3 mm (1.35 in.)
      c 20.9 mm (0.822 in.)

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL SERVO MOTOR

    Click here

  4. INSTALL SERVO MOTOR

    Click here

  5. INSTALL SERVO MOTOR

    Click here

  6. INSTALL REAR AIR MIX DAMPER CONTROL SERVO MOTOR RH

    Click here

  7. INSTALL COOLER EXPANSION VALVE (w/o Cool Box)

    Click here

  8. INSTALL AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY (w/ Cool Box)

    Click here

  9. INSTALL COOLER EXPANSION VALVE (w/ Cool Box)

    Click here

  10. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY

    Click here

  11. INSTALL AIR CONDITIONER HARNESS

    Click here

  12. INSTALL QUICK HEATER ASSEMBLY (w/ PTC Heater)

    Click here

  13. INSTALL COOLER REFRIGERANT LIQUID PIPE N (w/ Cool Box)

    Click here

  14. INSTALL ASPIRATOR

    Click here

  15. INSTALL BLOWER ASSEMBLY

    Click here