PROCEDURE
INSTALL REAR COOLING UNIT ASSEMBLY
Install the rear cooling unit assembly as shown in the illustration.
Install the 4 bolts.
Connect the 2 connectors.
INSTALL REAR ROOF NO. 1 AIR DUCT
Install the rear roof No. 1 air duct with the clip.
Attach the 2 claws to install the cooler plate.
CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
Remove the attached vinyl tape from the pipe.
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioner tube and accessory assembly.
Install the 2 O-rings to the air conditioner tube and accessory assembly.
Connect the air conditioner tube and accessory assembly.
Install the 2 nuts.
Connect the heater water inlet hose and heater water outlet hose.
Using pliers, grip the claws of the clips and slide the 2 clips.
INSTALL REAR BUMPER COVER
for Standard:
w/ Towing Hitch:
w/ Pintle Hook:
REMOVE REAR UPPER PILLAR GARNISH LH
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
INSTALL REAR DOOR SCUFF PLATE LH
INSTALL REAR STEP COVER
INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
INSTALL REAR NO. 2 SEAT ASSEMBLY LH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
ADD ENGINE COOLANT
for 3UR-FE:
for 1VD-FTV:
CHARGE REFRIGERANT
WARM UP ENGINE
CHECK FOR ENGINE COOLANT LEAKS
for 3UR-FE:
for 1VD-FTV:
CHECK FOR REFRIGERANT GAS LEAK
CHECK SRS WARNING LIGHT
INSTALL UPPER RADIATOR SUPPORT SEAL
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
for 3UR-FE:
for 1VD-FTV:
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
INITIALIZATION SERVO MOTOR