REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Seat Type 60 Side) INSTALLATION
CAUTION / NOTICE / HINT
Tech Tips
-
Use the same procedures for LHD and RHD vehicles.
-
The procedures listed below are for LHD vehicles.
-
A bolt without a torque specification is shown in the standard bolt chart Click here.
PROCEDURE
-
INSTALL NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH
-
Install the belt with the nut labeled A.
- Torque:
- 42 N*m { 428 kgf*cm, 31 ft.*lbf }
-
Install the belt sensor with the 3 nuts labeled B.
-
-
INSTALL REAR SEAT SHOULDER BELT HOLE COVER
-
Install the seat belt as shown in the illustration.
-
Attach the 3 claws to install the shoulder belt hole cover.
-
-
INSTALL REAR LOWER SEATBACK COVER SUB-ASSEMBLY LH
-
INSTALL REAR SEATBACK HINGE COVER LH
-
INSTALL SEATBACK COVER WITH PAD
-
INSTALL REAR SEAT BELT HOLE COVER LH
-
INSTALL SHOULDER BELT ANCHOR COVER
-
INSTALL REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
-
INSTALL REAR SEAT HEADREST ASSEMBLY
-
INSTALL REAR SEATBACK BOARD SUB-ASSEMBLY LH
-
INSTALL REAR SEATBACK COVER
-
INSTALL SEAT CUSHION COVER WITH PAD
-
INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
-
INSTALL REAR SEAT UNDER TRAY COVER LH
-
INSTALL REAR SEAT CUSHION COVER RH
-
INSTALL REAR UNDER SIDE COVER LH
-
INSTALL REAR SEATBACK STAY COVER LH
-
INSTALL SEAT BELT ANCHOR COVER CAP
-
INSTALL REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
-
INSTALL REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
-
INSTALL REAR NO. 2 SEAT PROTECTOR
-
INSTALL REAR NO. 2 SEAT LEG SIDE COVER
-
INSTALL UPPER SEAT TRACK RAIL COVER RH
-
INSTALL UPPER SEAT TRACK RAIL COVER LH
-
INSTALL REAR NO. 1 SEAT RECLINING COVER RH
-
INSTALL REAR NO. 1 SEAT RECLINING COVER LH
-
INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
-
INSTALL SEAT ADJUSTER BOLT COVER
-
INSTALL REAR NO. 1 SEAT ASSEMBLY LH
-
Install the rear No. 1 seat assembly Click here.
-