REAR CENTER SEAT OUTER BELT ASSEMBLY(for Rear No. 2 Seat) INSPECTION

PROCEDURE


  1. INSPECT REAR NO. 2 SEAT BELT ASSEMBLY 3 POINT TYPE

    A01WUABE01

    Note

    Do not disassemble the retractor.


    1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

      If the operation is not as specified, replace the belt.

    2. w/ Child Restraint System:

      Check the fastening function of the child restraint system.

      Note

      The check should be performed with the outer belt installed.


      1. When the belt is pulled out fully, the belt should automatically start to retract.

      2. After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the belt assembly.